Alfen | Eve Single - Configuration for ChargePilot

Connection to the charger

Local connection

Connect to the ACE Service Installer App

The ACE Service Installer uses broadcast messages to find the stations IP, thus if the laptop has an intranet connection to the charger, it will appear in the list of available chargers with their IPs. Please ensure your laptop is in the same subnet as the target charger by one of the connection ways:

1. Direct connection to the charger

   1. For the first time login, or the station has a static IP-address, connect your laptop directly with the charger (stand-alone)

   2. Change the IP-address of your laptop’s Ethernet port to the same IP range

2. Indirect connection to the charger via a DHCP server

   1. Connect your Ethernet cable to the router which is also connected to the charger and the DHCP server

Download page for the ACE Service Installer App

Login Data:
Username: <acquired from the vendor>
PW: <aquired from the vendor or customer>

OCPP settings

• Navigate to the Connectivity tab

• Check the box of “Advanced Settings”

• Select “Manually enter backend settings”

Backend

• Connection type: Ethernet

• OCPP Mode: OCPP-J 1.6

• OCPP Backend URL: ws://172.22.0.1:9000/

ChargeBox ID

• Navigate to the tab General tab

• Please check if the Customer Ident. number is equal to the serial number of the charger by default or according to the installation protocol

• Save the settings

Other charger settings

Authorization settings

• Navigate to the Authorization tab

• Configure the Parameters as follows:

  • Authorization mode: RFID

  • Online action: Wait for authorization by Backoffice

• Save the settings

Autocharge/Free charging settings

When this function is activated, charger starts transaction either with the identifier predefined in the charger, or with the EV MAC address (Plug & Charge).

• Navigate to the Authorization tab

• Configure the Parameters as follows:

  • Authorization mode: Plug&Charge

  • Plug & charge ID: PLUG&CHARGE

• The Plug & charge ID must be stored in the backend correspondingly

• Save the settings

Power Settings

• Navigate to the Power settings tab

• Ensure the station maximum current value won’t exceed the maximum fuse limit during charging processes

• Check the connector max current value and the connector type are set exactly

• Save the settings